Last previous edition approved in as D – Adopted as a joint ASTM/ IP standard in 2 For referenced ASTM standards, visit. Test Report of Foaming Characteristic (ASTM. D) and Air Release (ASTM D ). Test Report of Foaming Characteristic (ASTM. D) and Air Release. ASTM D Standard Test Method for Air Release Properties of Hydrocarbon Based Oils. standard by ASTM International, 10/01/ View all product.
|Published (Last):||15 September 2014|
|PDF File Size:||15.64 Mb|
|ePub File Size:||8.84 Mb|
|Price:||Free* [*Free Regsitration Required]|
A temperature sensor of at least equivalent performance is also suitable. Digital timer alarm, easy to operate.
Build-in air heater, safe and fast Technical parameters 1. If the residence time in the reservoir is too short to allow the air bubbles to rise to the oil surface, a mixture of air and oil will circulate through the ast, oil system.
Digital air release properties tester, astm d3427 lubricating oil testing equipment
Since some reports were incomplete, this resulted in 48 pairs of replicated data. It is used to test the ability of turbine, hydraulic, and gear oils to separate entrained air. This test may not be suitable for ranking oils in applications where residence times are short and gas contents are high Features 1.
If the loss causes any part of the sinker to be exposed, discontinue the test and repeat, using a sample that is 10 mL larger than previously used. Box 70, Burlington, NJ c3427 This can be implemented by recording the density at intervals, as required. The significance of this test method has not been fully established.
If the time is greater than 30 min, discontinue the test.
Send your message to this supplier. Where air release value information is required for such oils, an air releasing time curve may be drawn.
China Air Release Value Apparatus ASTM D – China Air Release Testing, Release Value Apparatus
This may result in an inability to maintain oil pressure particularly with centrifugal pumpsincomplete oil films in bearings and gears, and poor hydraulic system performance or failure.
This apparatus measures the time for the entrained air content to fall to the relatively low value of 0. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters.
The two parts of each test vessel should be marked and preferably used as a pair. Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm.
Preparation of Apparatus 8. Five samples were tested at one temperature and four at another. However, entrained air cancause sponginess and lack of sensitivity of the control of turbine and hydraulic d347. For ready comparison, the above statement is shown in DIN terms in Table 1.
Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.
However, entrained air can cause sponginess and lack of sensitivity of the control of turbine and hydraulic systems. You have seen all photos.
ASTM D3427 Lubricating Oil Air Release Value Test Device (TP-0308)
China soxhlet apparatus China flash point apparatus China thermal conductivity apparatus. Send This is not what you are looking for? This apparatus measures the time for the entrained air content to fall to the relatively low value of 0. NOTE 1—This test method was developed for mineral based oils. Last previous edition approved in as D — Use of a pressure relief valve set at 70 kPa 10 psi is recommended.
When the sinker has reached the test temperature, immerse it in x3427 sample, taking care that no air bubbles cling to it.
However, the precision at these different temperatures is not known at present. China vicat apparatus China dissolution apparatus China vacuum filtration apparatus.